22.
Data on ^B01:
When enabled, NetLink will immediately
begin sending data when the data release command is
invoked (Menu or ^B01). When disabled, NetLink will
send the "READY" message, then wait for Command ^B02
before releasing data. (
Default = On
).
23.
Hold End Data:
At the end of each data release session,
NetLink will send the "End Data" message before returning
to Command Mode. When "Hold End Data" is enabled, this
port will wait for Command ^B02 before sending the End
Data message. (
Default = On
).
24.
Line # Tag:
Inserts a Line Number at the beginning of each
record or block released by this port. These Line Numbers
are not stored in NetLink’s internal memory, but are added
when data is released.
(Default = Off)
.
25.
Send Compressed:
Determines whether this port will
release data in space compressed or normal format.
(Default = Off)
.
26.
Auto Delete:
When enabled, data will be automatically
deleted from NetLink's memory at the end of each
successful read. If the read is interrupted, data will
not
be
deleted.
(Default = Off)
.
Note:
Before enabling the Auto Delete function,
please refer to the cautions listed in Section 15.6.
Output Parameters (Binary Block Mode Only):
27.
Transmit Attempts: (
Binary Mode Only) Determines how
many times this port will resend a block after a transmission
interruption, or lost connection.
(Zero to 99 attempts;
Default = 3
).
28.
Transmit Delay:
(Binary Mode Only) Determines how
long this port will wait between transmit attempts. If this
value is set to Zero, binary data will be sent in a continuous
block, without acknowledgment. (Zero to 99 seconds;
Default = 5 seconds
).
29.
DLE Stuffing:
(Binary Mode Only) Allows literal
characters to be inserted into binary data released by this
port.
(Default = Off)
.
4-20
PollCat NetLink User's Guide
Summary of Contents for PollCat NetLink
