3.
Access via TCP/IP Network:
If network parameters for
the NetLink unit have been assigned (see Section 4.4.5),
establish a telnet session using the following format:
telnet ipaddress [port]
[Enter]
Where:
ipaddress
NetLink's assigned IP Address.
port
(Optional) The desired Port Number. If this
item is omitted, telnet will connect to port #23
by default; Command Echo will be set according
to NetLink's current configuration, and $FF
Stuffing will be enabled. Options:
2001
Behaves the same as Port #23.
3001
Preconfigured with echo enabled
and $FF Stuffing Off.
a) If the password is enabled, the "PollCat-NetLink"
(password) prompt will appear.
b) Key in a valid password and press
[Enter]
. Note that
the Password feature is case-sensitive.
c) After a brief pause, the Main Menu or the "Ready"
prompt will appear. If the "Ready" prompt is displayed,
press
[Enter]
to display the NetLink Main Menu.
d) To end a session, disconnect using your telnet software.
18.2. Command Syntax
Most commands conform to the following conventions:
·
Commands normally begin with the ASCII "Control B"
character (written as
^B
throughout this manual).
·
To temporarily suppress the Command Echo for any
command, use the ^A character in place of the ^B character.
For example, if Command Echo is enabled and Command
^B03 (Send Site ID) is invoked, NetLink will echo the
command back to the polling device and send the Site ID
message. If ^A is substituted for ^B (e.g.
^A03
), the Site ID
message will be sent, but the command will
not
be echoed
back to the polling device.
·
Each command is invoked by pressing the
[Enter]
key.
·
A comma (
,
) is used to separate a command from its options
or parameters (e.g.
^B01,10
).
18-2
PollCat NetLink User's Guide
Summary of Contents for PollCat NetLink
