^
B90
Reset Modem Port / Define Modem Port
Communication Parameters
(Supervisor Mode Only)
This command can be used to reset
NetLink's internal modem or redefine modem communication
parameters.
Reset Modem:
To reset the modem, use the following format:
^B90
Reset Modem
^B90,y
Reset Modem, Suppress "Sure?" Prompt.
Configure Modem Port:
To define modem communication
parameters, use the following format:
^B90,baud,parity,data,stop
[Enter]
Where:
baud
Baud Rate:
Any standard rate from 300 bps to 115.2
Kbps. Note that it is only necessary to enter the first two
characters of the baud rate. If an asterisk is entered in this
field, the port will be set to the default modem port
baud rate (57.6 Kbps).
parity
Parity Bits:
None (
n
), Odd (
o
), or Even (
e
)
data
Data Bits:
7
or
8
stop
Stop Bits:
1
or
2
Corresponding Menu Function:
Modem Port Config. Menu.
^
B91
Define Console Port Communication
Parameters
(Supervisor Mode Only)
Defines the baud rate, parity, data bits,
and stop bits for the Console Port. This command uses the
following format:
^B91,baud,parity,data,stop
[Enter]
Where:
baud
Baud Rate:
Any standard rate from 300 bps to 115.2
Kbps. Note that it is only necessary to enter the first two
characters of the baud rate. If an asterisk is entered in this
field, the port will be set at the default rate specified by
set-up switches 1, 2, and 3.
parity
Parity Bits:
None (
n
), Odd (
o
), or Even (
e
)
data
Data Bits:
7
or
8
stop
Stop Bits:
1
or
2
Corresponding Menu Function:
Console Port Config. Menu.
18-28
PollCat NetLink User's Guide
Summary of Contents for PollCat NetLink
