WTI PollCat NetLink, User Manual, Page: 39 / 256

7. Reset Network: Reinitializes the network port.
11. Command Echo: Enables / Disables the command echo for
this port. During set-up, it may be helpful to enable
Command Echo. This allows keystrokes sent to the NetLink
to be displayed on your monitor. (Default = On) .
12. Response Type: Determines how this port will react when
Command Mode is activated. If "Display Menu" is
selected, NetLink will immediately display the Main Menu
when Command Mode is activated. If "Inhibit Menu" is
selected, NetLink will not display the Main Menu until
[Enter] is pressed. (Default = Inhibit Menu)
13. "Sure" Prompt: When irreversible commands (such as
"Erase Data") are invoked, this port can display the "Sure"
prompt to allow one last chance to verify that the command
should be executed. (Default = On) .
14. Command Timeout: Sets the Timeout value. If no
additional command activity is detected at this port during
the defined timeout period, this port will exit Command
Mode and disconnect. (Default =15 minutes) .
15. Audit Trail: Enables or Disables the Audit Trail function.
When enabled, NetLink will log command activity at this
port. To review the command activity log, please refer to
Section 16.1.7. (Default = Off) .
Action Parameters:
16. Action Delay: When multiple alarm actions are directed to
this port, the action delay determines how much time will
elapse between actions. This makes it easier to connect to
the port, by providing a window when the port is not busy
sending out actions. (Zero to 9999 Seconds;
Default = 10 Seconds ).
Output Parameters:
21. Output Mode: Selects the data output format for this port;
ASCII Record, Binary Block, Xmodem or Zmodem.
(Default = ASCII Record) .
Note: When using Zmodem Output Mode, please
refer to the cautions listed in Section 15.7.
4-19
Program Set-Up