Wincor Nixdorf TH210, Programmer'S Manual

Page: 76 / 152

TH210 Programmer’s Guide
72
Bit Off/On Hex Decimal Function
5 Off 00 0 No unrecoverable error.
On 20 32 Unrecoverable error occurred.
6 Off 00 0 Thermal printhead temp. and power supply
voltage are in range.
On 40 64 Thermal printhead temp. or power supply voltage
are out of range.
7 Off 00 0 Fixed to off
4 = Transmit receipt paper status
Bit Off/On Hex Decimal Function
0 Off 00 0 Fixed to off
1 On 02 2 Fixed to on
2 Off 00 0 Paper adequate
On 04 4 Paper low (if paper low sensor enabled)
3 Off 00 0 Paper adequate
On 08 8 Paper low (if paper low sensor enabled)
4 On 10 16 Fixed to on
5 Off 00 0 Paper present
On 20 32 Paper exhausted
6 Off 00 0 Paper present
On 40 64 Paper exhausted
7 Off 00 0 Fixed to off
Real time request to printer
GS sequence DLE sequence
ASCII
Hexadecimal
Decimal GS ETX n
1D 03 n
29 3 n
DLE ENQ n
10 05 n
16 5 n
Value of n : 1 = recover and restart
2 = recover and clear buffers
The printer responds to a request from the host specified by n . This command includes two
sequences: GS and DLE. This command can be disabled using 1F 7A. If in page mode, the printer is
set back to standard mode, causing values set by 1B 57 to be changed back to default. The
operations performed depend on the value of
n , according to the following parameters.
n = 1
Restarts printing from the beginning of the line where an error occurred, after recovering from the
error. Print settings that are normally preserved from line to line, such as character height and
width, are still preserved with this command. This sequence is ignored except when the printer is
busy due to an error condition.
This command will attempt recovery from a knife error. Other errors associated with the receipt,
such as paper out or printhead overheating, can be recovered from only by clearing the specific
condition, such as loading paper or letting the printhead cool down.