Wincor Nixdorf TH210, Programmer'S Manual

Page: 100 / 152

TH210 Programmer’s Guide
96
Select print direction in page mode
ASCII
Hexadecimal
Decimal
Value of
n :
EST T n
1B 54 n
27 84 n
Start position
0 = Upper left corner proceeding across page to the right [A]
1 = Lower left corner proceeding up the page [B]
2 = Lower right corner proceeding across page to the left (upside down) [C]
3 = Upper right corner proceeding down page [D]
Default:
0
Selects the printing direction and start position in page mode. See the illustration below.
The command can be sent multiple times so that several different print areas, aligned in different
print directions, can be developed in the printer’s page buffer before being printed using the print
page mode commands (0C or 1B 0C).
Starting
Position Commands Using Motion Unit
Upper
Left/Lower
Right 1B 20, 1B 24, 1B 5C (horizontal motion unit)
1B 33, 1B 4A, 1D 24, 1D 5C (vertical motion
unit)
Upper
Right/Lower
Left 1B 33, 1B 4A, 1D 24, 1D 5C (horizontal motion
unit)
1B 20, 1B 24, 1B 5C (vertical motion unit)
Exceptions
The command is valid only in page mode.
The command is ignored if the value of n is out of the specified range.
If this command is processed in standard mode, print direction is not changed until the printer is
set to page mode.
Select print area in page mode
ASCII
Hexadecimal
Decimal
Range of
n :
ESC W n1, n2 1B 1B 57 n1,
n2 ...n8
27 87 n1, n2 ...n8
0-255
Default:
n1-4 = 0
n5 = 64
n6 = 2
n7 = 64
n8 = 2
(576x576 for 80 mm paper)