Wincor Nixdorf TH210, Programmer'S Manual

Page: 99 / 152

TH210 Programmer’s Guide
95

Set counter-clockwise rotation (1B 12)

Select justification (1B 61)

Select or cancel upside-down printing (1B 7B)

Set left margin (1D 4C)

Set print area width (1D 57)
The table below shows the difference in memory allocation in page mode when using
monochrome and two-color paper. Two-color paper mode requires extra memory in order to
differentiate between non-black and black.
Paper type Total memory allocated (kBytes) Area of construction (mm)
Monochrome paper 40.5 72 wide x 72 high
Printer returns to standard mode through use of 0C, 1B 53, or initialization (which cancels all
settings).
Exceptions
The command is enabled only when input at the beginning of a line.
The command has no effect if page mode has previously been selected.
Select standard mode
ASCII
Hexadecimal
Decimal ESC S
1B 53
27 83
Switches from page mode to standard mode. In switching from page mode to standard mode, data
buffered in page mode are cleared, the printing area set by set print area in page mode (1B 57) is
initialized and the print position is set to the beginning of the line.
This command switches the settings for the following commands (the values for these commands
can be set independently in standard mode and page mode) to those for standard mode:

Set right-side character spacing (1B 20)

Select 1/6-inch line spacing (1B 32)

Set line spacing (1B 33)
Standard mode is automatically selected when power is turned on, the printer is reset, or the
initialize printer command (1B 40) is used.
18, 1B 0C, 1D 24, and 1D 5C commands are ignored in standard mode.
Exceptions
This command is effective only in page mode.