Wincor Nixdorf TH210, Programmer'S Manual

Page: 78 / 152

TH210 Programmer’s Guide
74
Real time commands disabled
ASCII
Hexadecimal
Decimal US z n
1F 7A n
31 122 n
Value of n : 0 = enable
1 = disable
This command is used to disable real time commands. They are disabled prior to sending graphic
or other data to the printer that may contain embedded real time commands.
The command is a batch command and processed in the order received.
Automatic Status Back
Enable/disable Automatic Status Back (ASB)
ASCII
Hexadecimal
Decimal GS a n
1D 61 n
29 97 n
Range of n : 0 - 255
Default: 0 (ASB disabled)
Enables or disables automatic status back (ASB) and specifies the status items. This command is a
batch mode command; that is, it is processed after all prior data in the input buffer has been
processed. There may be a time lag between the printer receiving this command and changing the
ASB response, depending on the receive buffer contents.
If any of the status items listed are selected, ASB is enabled and the printer automatically transmits
4 status bytes whenever the selected status changes. If no status is selected, ASB is disabled. All
four status bytes are transmitted without checking DSR
If the error status is enabled, a change in the following conditions will trigger the ASB:

Cash Drawer

Receipt Cover

Knife Error

Out-of-Range Printhead Temperature

Out-of-Range Voltage

Paper Exhaust Status
The bits of n are defined in the table.
Bit Off/On Hex Decimal Status for ASB
0 Off 00 0 Cash drawer status disabled.
On 01 1 Cash drawer status enabled.
1 Off 00 0 RS-232C Busy status disabled.
On 02 2 RS-232C Busy status enabled.
2 Off 00 0 Error status disabled.
On 04 4 Error status enabled.
3 Off 00 0 Receipt paper roll status disabled.
On 08 8 Receipt paper roll status enabled.