Wincor Nixdorf TH210, Programmer'S Manual

Page: 30 / 152

TH210 Programmer’s Guide
26
Related information
Other bits of n (1–7) are undefined and ignored.
When the printer is disabled by this command, it ignores transmitted data until the printer is re-
enabled by the same command.
Initialize printer
ASCII ESC @
Hexadecimal 1B 40
Decimal 27 64
Default: Character pitch: 15.6 CPI
Column width: 44 characters
Extra dot rows: 3
Character set: Code Page 437
Printing position: Column One
Clears the print line buffer and resets the printer to the default settings for the start-up
configuration (refer to Default settings above). Data in the receive buffer is not cleared, and
printing position moves to the beginning of the line.
Single-wide, single-high, non-rotated, and left-aligned characters are set, and user-defined
characters or logo graphics are cleared. (Flash memory and macros are not affected.) Tabs reset to
default. Receipt selection state is selected. Barcode settings reset. Page mode settings are cleared
and printer is set to standard mode. ASB is switched off.
Select sensors to stop printing
ASCII ESC c 4 n
Hexadecimal 1B 63 34 n
Decimal 27 99 52 n
Value of n : Sensor status
Sensor Status
Bit
Sensor 0 1
0 Receipt paper near-end Disabled Enabled
1 Receipt paper near-end Disabled Enabled
2-4 Undefined
6 Undefined
Bits 5 and & are not used.
Default: 0
Determines which sensor stops printing on the respective station. The command does not affect
the paper out status on the receipt station, which will automatically stop the printer when the
paper is depleted.