Wincor Nixdorf TH210, Programmer'S Manual

Page: 60 / 152

TH210 Programmer’s Guide
56
Download font
ASCII GS 0xF0 0x80 followed by file
Hexadecimal 1D F0 80
Decimal 29 240 128
This command is the sequence introducer for downloading existing files.
The downloaded font is always stored in the permanent font area of flash. If there is not enough
memory in the permanent font area to store the file the printer returns NACK.
When the file is downloaded the printer returns ACK.
If the file contents are incorrect the printer returns NACK. File format to be described in appendix.
So the full sequence for downloading files as font ID CB would be:
1D F0 01 CB
1D F0 80 followed by map file shftjis.chr
1D F0 02 02
1B 20 n for horizontal character spacing 1B 33 n
1B 33 n for vertical character spacing
1D F0 80 followed by character definition file shftj24.chr
Graphics
These commands are used to enter and print graphics data and are described in order of their
hexadecimal codes, unless otherwise noted.
These commands describe operation for 80mm paper.
Download BMP logo
ASCII ESC (+*.BMP file)
Hexadecimal 1B (+*.BMP file)
Decimal 27 66 77(+*.BMP file)
Value Maximum width = 576
Maximum height = 512
Enters a downloaded BMP logo into RAM or flash.
The downloaded BMP logo can be printed by using the print downloaded bit image (1D 2F m)
command.
To downloaded BMP file to save it as a logo, send the hexadecimal code 1B followed by the whole
BMP file.
The printer decodes the BMP file header and will save the image data after checking important
parameters, such as:

Width

Height

Number of colors (only monochrome images are accepted)
BMPs and bit images continue to be definable only for the receipt station. However, there is no
longer an automatic erasure whenever the user downloads a character set (as happened
previously) as well as in the case where the current logo was never set > 0, (the automatic erasure
if user flash memory had filled up with inactive logo 0 definitions upon next power cycle).