Vision MaxPro, Operation Manual

Page: 51 / 203

Configuration 47
© 2006 Vision Engraving Systems
To remove the T-Slot table, remove the four Allen head screws from the top of the T-Slot
table per the picture below. There are two screws on the top left and two on the top right of
the T-Slot table.
The T-Slot table can now be taken off. Please note that once the screws are removed, the
table must be removed by pulling up evenly on the table as it is resting on four pins for
alignment. Be careful not to lose the pins.
To re-install the T-Slot table, open or close the vice until the pins in the top of the vice line up
with the holes in the T-Slot table. Insert and tighten the four Allen head screws. The T-Slot
table is now ready for use.