Vision MaxPro, Operation Manual

Page: 14 / 203

Vision MaxPro 10
© 2006 Vision Engraving Systems
9. Number 9 in figure 2.2 is where the 110 volt power is plugged into.
Note:
220 volts can
be used if the machine is configured to accept 220 volts. There is typically a yellow label
near the plug if the machine is configured for 220 volts.
10. Looking from the back side of the machine, plug in the small cable from the right upright
into the plug labeled 10 in figure 2.2. This is used to power the water pump.
11. Connect the thin gray auxiliary plug (extending from the auxiliary power box) to the plug
labeled 11 in figure 2.2. (
Note:
This is an optional auxiliary power box used only with a
vacuum chip removal system. If a vacuum chip removal system is not required, there is
no need for the auxiliary power box).
The MaxPro Engraver is now connected properly.
Configuring the PC
Using a Network Connection
There are two different types of network connection methods that can be used for the
MaxPro Engraver. Connect the supplied network cable to the network plug on the back of
the MaxPro. The other end of the network cable connects in one of two ways.
Direct to the PC
If you are connecting the MaxPro directly to a PC and not through a network server, please
attach the supplied network crossover adaptor to the end of the network cable. Then plug
the adaptor directly into the network connection in the back of your PC. The IP address will
need to be manually entered into the Vision controller. To do this, follow the steps below:
1. Turn the MaxPro on. After a few seconds, the machine will boot up.
2. Press the Menu button on the hand held pendant.
3. Press the Y down jog button ten times.
4. The cursor will be on Ethernet Settings. Press the Enter button on the pendant.
5. The cursor will be on Specify IP. Press the Enter button on the controller.
6. Press the EXIT button on the controller to specify an IP address.
7. Using the number pad on the pendant, type 192 and press Enter.
8. Type 168 and then Enter.
9. Type 5 and then Enter.
10. Type 101 and then Enter.
11. The Enter NetMask screen will show on the LCD screen. Type 255 and then Enter.
12. Type 255 and then Enter.
13. Type 255 and then Enter.
14. Type 0 and then Enter.