MNL000424.doc
Revision 00
08/26/2016
© Versum Materials, Inc. as of the revision and date shown. All rights reserved.
Confidential and Proprietary Data
Page
-
14
probe tip is covered with oil. Then reinstall the temperature probe into the thermowell.
Note: perform this check with the unit powered down. Also, the oil does not need to be
replaced unless it has been contaminated with a chemical.
6.3.7
VaporGuard® Fan Clearance
It is recommended that there be at least 6 inches of clearance for the fan inlet and
outlet from a wall. The system will work with a wall that is only one inch from its inlet or
outlet sides, however, with reduced performance. If 6 inches is unattainable, the
customer should select a location that gives the VaporGuard® the most clearance.
6.3.8
Cables
CAUTION: Use of a cable
with an incorrect part number
could create a hazardous
condition.
Care must be exercised that
the system is not connected
to a source of power other
than that indicated on the
Rear Panel Label.
CAUTION
VORSICHT: Die Benutzung
eines Kabels mit falscher
Teilenummer kann zu einer
Gefahrensituation führen.
Es ist zu beachten, daß das
System nur an die
Stromquelle angeschlossen
werden darf, die auf dem
Schild an der
Geräterückwand angegeben
ist.
ATTENTION: L’utilisation
d’un câble dont le numéro de
pièce est incorrect peut
entraîner une condition
dangereuse.
Prenez soin de vérifier que le
système ne soit pas raccordé
à une alimentation électrique
autre que celle indiquée sur
l’étiquette de panneau arrière
