Vacon apfiff09 marine, Applications Manual, Page: 93 / 310

92
• VACON®
apfiff09 marine
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
6.15 Brake Control
Code Parameter Min Max Unit Default Cust ID Note
P2.15.1 BrakeMechDelay 0.00 320.00 s 0.00 1544
Time that is required to
open the brake
P2.15.2
Brake OFF FreqLim
Open Loop
0.00 320.00 Hz 1.50 1535
Opening limit and
maximum reference limit
when brake is closed.
P2.15.3
Brake OFF FreqLim
Closed Loop
0.00 320.00 Hz 0.00 1555
Opening limit and
maximum reference limit
when brake is closed.
P2.15.4
Brake ON FreqLim
+
0.00 320.00 Hz 1.00 1539
Close frequency from
positive direction
P2.15.5 Brake ON FreqLim - 0.00 320.00 Hz 1.50 1540
Close frequency from
negative direction
P2.15.6
Brake On/Off
Current Limit
0.00 320.00 A 0.00 1085
Brake is closed
immediately id current
goes below this value.
P2.15.7
Generator Torque
limit increase speed
level
0.00 320.00 Hz 0.00 1547
Function disabled when
zero. Point where
Generator torque limit
stars to increase.
P2.15.8
Generator Torque
limit increase
maximum speed
limit
0.00 320.00 Hz 100.00 1548
Point where torque value
of ID1549 is added to
base generator torque
limit.
P2.15.9
Generator Torque
limit increase
maximum addition
0.0 300.0 % 300.0 1549
P2.15.10 Brake Fault Action 1 3 1 1316
1 =Warning
2 =Fault,stop acc. to
2.3.2
3 =Fault,stop by coasting
P2.15.11 Brake Fault Delay 0.00 320.00 s 0.20 1317
Table 6-76. Brake control parameters, G2.15
6.15.1.1 Brake Control Start up torque for CL
Code Parameter Min Max Unit Default Cust ID Note
P2.15.12.
1
Start-up torque 0 3 0 621
0 =Not used
1 =Torque memory
2 =Torque reference
3 =Start-up torque fwd/rev
P2.15.12.
2
Start-up torque FWD
–
300.0 300.0 s 0.0 633
P2.15.12.
3
Start-up torque REV
–
300.0 300.0 s 0.0 634
P2.15.12.
4
Start Up Torque
Time
-1 10000 ms -1 1371 -1 = Automatic
Table 6-77. Brake control start up torque parameters, G2.15.12
6.15.1.2 Roll Back Control for CL
Code Parameter Min Max Unit Default Cust ID Note
P2.15.13.
1
Roll Back Kp 0 1787
P2.15.13.
2
Roll Back Torque 0,0 1788
P2.15.13.
3
Roll Back Level 3 1789
P2.15.13.
4
Roll Back Kp 2 0 1792
Table 6-78. Brake control roll back control parameters, G2.15.13