Universal Devices ISY-994i Series, User Manual

Page: 59 / 692

Page | 36
Figure 30: Add Button to IRLinc Receiver
Note: The Scene Control buttons (A-H) are On/Bright, Off/Dim buttons and control only
one scene. Once either the On or Off button is linked to the ISY the other button is
automatically linked.
Create Non-Toggle Links - (Always sends only on/off commands)
This can be handy if you want to create a button that is “All Off” or “Movie Time” (or other
situations where you want the button to do the same thing every time you press it). This is
also sometimes referred to as “non - toggle” mode.
•
Select the "Add Button to IRLinc Receiver in the ISY Link Management pulldown
menu
•
Press & hold the IRLinc Set button for about 5 seconds, then release
o
Blue LED will turn Off
•
Point your IR remote at IR Receiver, and press the button to be learned
o
Blue LED will begin blinking
•
Tap IRLinc’s Set button once (to always send an on), or twice (to always send an off)
o
Blue LED will continue blinking
•
On the ISY, click on Ok to link the learned button to ISY
o
Blue LED will return to on as normal after ISY completes linking
Optional: Factory Resetting your IRLinc
If you remove all the links to the IRLinc from the ISY it should clean up everything, but just
in case you need to you can factory reset the IRLinc before linking it to the ISY.
•
Unlink all the links in you ISY to the IRLinc
•
Unplug the IRLinc, wait 10 seconds
•
Press and continue to hold the Set button for 5 seconds while plugging the unit back
in, then release
o
About 20 seconds after releasing the Set button, blue LED will flash twice to
indicate a successful reset
o
Note: Blue LED may or may not be on during reset