Unipulse F156, Operation Manual

Page: 23 / 160

3.CC-LINK INTERFACE
14
3. CC-LINK INTERFACE
3-1. Outline
With the F156, standard-loaded with the CC-Link interface (capable of the latest Ver.1.10), you
can easily construct a high-speed weighing system on the CC-Link network.
The F156 is a remote device occupying two stations. In the case of construction with the F156
alone, up to 32 units, including one master, can be connected to the bus.
All commands and parameters executable with the console can be set on the CC-Link.
Therefore, jobs can quickly be changed in a large-scale weighing system using a large number
of load cells.
3-2. Communication Setting Rotary Switch
Decide the station number and baud rate.
Be careful not to make invalid settings.
These settings are read when the power is turned on.
・
Baud rate 0
：
156k, 1
：
625k, 2
：
2.5M, 3
：
5M, 4
：
10M
3-3. Communication Status Indicators
The communication status is indicated by LED.
Setting range
Station No. 1 to 63
Baud rate 0 to 4
CAUTION
About setting of Mitsubishi general-purpose PLC CPU unit
If using Mitsubishi general-purpose PLC MELSEC-Q series, please set the
mode configuration and station type as following in the configuration of
master station network parameters.
- Mode configuration: Remote net Ver.1 mode
- Station type:
Remote device stations
(“Station information” → “Station type”)
LED name LED ON LED OFF LED Blinking
RUN
・
Normal
・
Reset action
・
No communication
SD
・
Transmitting
RD
・
Receiving
ERR
・
Setting error
・
CRC error
・
Fault
・
Normal
・
Power-on-time
switch setting
changed