1
．
PART NAMES AND FUNCTIONS
4
⑩
RS-232C mode and baud rate setting rotary DIP SW
Set the console mode at 0, and the baud rate in the RS-232C communication mode at 1 – 6 as
follows:
⑪
AC power input terminals (red screws)
Input 100V 50/60Hz as the standard.
⑫
Frame ground terminal
Be sure to ground (low ground resistance where possible).
⑬
Power and system indicator (green LED)
LED ON during normal operation, functioning as a power lamp.
LED blinking during calibration, and when a fatal system error occurs.
List of functions
* Obstacles may be failure, mis-wiring, overload, etc., of the load cell.
No.
Mode and baud rate
0 :
Console mode (C110 or C120)
1 :
1200 bps
2 :
2400 bps
3 :
4800 bps
4 :
9600 bps
5 :
19200 bps
6 :
38400 bps
7 to 9 : Setting disabled
Rotary switch (mode and baud rate)
RS-232C communication mode
LED status
System status
Remark
LED ON
During normal operation
LED Blinking with
50% duty
During calibration
Automatically restored
to the lighting state when
calibration is normally
completed
LED Blinking with
low duty at a short
lighting time
Load cell power supply
shutdown with voltage
trouble between power
feS and –S
Remove obstacles, and
then turn the power off
and on again. *
LED Blinking with
high duty at a long
lighting time
Voltage drop of the back-
up lithium battery
For replacement of the
battery, contact us.
Summary of Contents for F156
Page 1: ...F156 WEIGHING CONTROLLER 07 JUN 2012 REV 1 40 OPERATION MANUAL CC Link Ver 1 10...
Page 115: ...7 REMOTE CONSOLE UNIT 106 Monitor change Change the display with the key...
Page 120: ...7 REMOTE CONSOLE UNIT 111 Monitor change Change the display with the keys 0 to 9 1 2 3 4 5 0...
Page 155: ...13 DIMENSIONS 146 13 DIMENSIONS...
