Unipulse F156, Operation Manual

Page: 154 / 160

12.ERROR CODES
145
◇
Command errors (error code=3)
◇
System errors (error code=4)
◇
Sequence error (error code=5)
* SP1 = Final – Set point 1
When two or more errors occur, priority is given as shown below.
EXC error
＞
Calibration error (1 – 9)
＞
Weight error
＞
Sequence error
＞
Command error
＞
Low battery
When two or more weight errors occur, priority is given as shown below.
-LOAD
＞
LOAD
＞
OFL2
＞
OFL3
＞
OFL1
＞
Zero alarm
Contents of error
Error
assistance code
Console
message
Command not in the command list 1 No change
Attempt to write read-only data
Attempt to read out write-only data
Attempt to write with the lock ON
2 No change
Writing data larger than 99999 3 No change
During zero calibration or span calibration 4 No change
Contents of error
Error
assistance code
Console
message
EXC alarm (*)
Obstacles to the exciter power supply
1 SHtdn
Low battery
Back-up battery voltage drop
2 No change
* The EXC alarm has priority over other errors. Therefore, if two or more errors including this error
occur at the same time, the error code becomes 41.
Contents of error
Error
assistance code
Console
message
The stop signal is ON when weighing starts. 1 sErr1
The stop signal turned ON during weighing to stop
weighing.
2 sErr2
Auto zero was operated by the setting of auto zero times,
giving a zero alarm.
3 sErr3
The near zero signal is OFF when weighing starts.
(when the check is set at ON)
4 sErr4
The weight value ≧ SP1* when weighing starts.
(when the check is set at ON)
5 sErr5