TV One C2-5000 Series, Operation Manual

Page: 59 / 116

C2-5000 Series Universal Scaler Operation Manual
59
14.5 SDI2 Input Type (C2-5200 Only)
Adjust lock/overlay
SDI2 Input Type [NTSC]
This parameter allows the selection of the second SDI input (Genlock) to be set.
This can only be set to either the PAL or NTSC standard.
15.0 ADJUST BUTTONS SUB MENU
The Fourth Sub Menu is for changing the Button assignments. This was covered
in the Quick Start section of the manual and is presented again here along with
adjustment procedures for
Preset , Instant Program Select and Preview Follow
modes:
The following example shows how you would select RGB1 as the input for button
number 3. All input assignments are made using the same procedure. To begin,
press button number 3 on the Scaler so you can see the result of your efforts.
Turn the Menu Select knob until you are parked on the following screen:
Sub menu
Adjust Buttons
Press the Menu Select Knob once to advise the Scaler that you want to make an
adjustment to the input assignments of one of the buttons. When you do, you’ll
be rewarded with the following LCD display:
Adjust Buttons
Button [ 1]= input=RGB1
Pressing the Menu Select Knob again will cause the brackets surrounding the
number “1” to begin flashing. Turn the Menu Select knob to the right until the
number “3” appears between the flashing brackets. When it does, press the
Menu Select knob again to load the number “3” into the Scaler’s memory. The
brackets will stop flashing and display should look like this:
Adjust Buttons
Button [ 3]= input=RGB3
Rotate the Menu Select knob one detent to the right and press the knob again.
This notifies the Scaler that you are about to change the input assignment to
input number “3”. The brackets will disappear from around the input number and
will appear around the section of the display that says “input=RGB3”. The LCD
screen will look like this:
Adjust Buttons
Button 3 = [input=RGB3]