C2-5000 Series Universal Scaler Operation Manual
45
12.9 Brightness and Contrast (CV, YC)
When your input selection is Composite Video (CV) or S-Video (YC), you have
access to several screens that only work with those two signal formats.
Brightness and Contrast are terms known to virtually anyone who has ever
operated a television receiver and the adjustment is straightforward.
After selecting the CV or YC image, (we are using CV1), rotate the Menu Select
knob until the following screen appears:
Program Source CV1
Bright [100] Contrast 100
Press the Menu Select knob and the left-hand brackets will begin to flash. Using
the knob, adjust the Brightness of the image to your requirement. Note that the
adjustment range is 0 to 180 with 100 being the default level. Once you have
made the adjustment, pressing the knob once stores the value in temporary
memory and causes the left brackets to stop flashing. Next, rotate the knob to the
right and press it once to start the right-hand set of brackets flashing.
The value within these brackets is the setting for the picture Contrast value and it
also has a range of 0 to 180 with 100 being the default. Pressing the Menu
Select knob will store your new Contrast value in temporary memory. As always,
if you want to make the settings permanent, press and hold the Menu Select
knob until you hear the ‘Beep’ for both Brightness and Contrast.
12.10 Saturation and Hue (CV, YC)
Again using the television receiver analogy, you probably already know what
functions Saturation and Hue represent. Adjustment of Saturation increases or
decreases the amount of color in the image and adjusting Hue changes the
appearance of the various colors within an image.
Program Source CV1
Satur [100] Hue 0
Select a CV or YC image (we’re using CV1 again in our example) and then rotate
the Menu Select knob until you’re displaying the LCD screen shown above. The
mechanics of selecting the item to be adjusted are the same as before: after you
are parked on the screen, press the Menu Select knob and the left-hand brackets
will begin to flash. Rotate the knob between the values of 0 and 180 until you
have the desired amount of Saturation (with 100 being the default value) and
then press the knob to load your selection into temporary memory. With this
selection made, the left-hand set of brackets will cease flashing. Rotate the knob
to the right and press it once which will start the right hand brackets flashing. You
Summary of Contents for C2-5000 Series
