C2-5000 Series Universal Scaler Operation Manual
30
Pressing the knob again causes the brackets to begin flashing. Rotate the Menu
Select knob to the right to zoom the image up to 1000%. Press the knob once to
load the value into memory.
Enlarging the center of the image is nice but what if you are interested in
something other than the middle of a picture? Fortunately, there are adjustments
available that allow you to pan the image both horizontally and vertically.
After you have selected and saved the zoom percentage, rotate the Menu Select
knob to the right until you see the following screen:
Adjust Scaler Parameters
H/V zoom pan % [ 50] 50
Pressing the knob will cause the brackets surrounding the left number to begin
flashing. Rotating the knob will cause a horizontal movement of the image with a
Clockwise rotation causing the image to move to the left and a Counter-clockwise
rotation causing a movement to the right. When you have reached the desired
position horizontally, press the knob to load the result into memory. Move the
brackets over to the right hand number by rotating the knob one detent to the
right and pressing the knob. The brackets will begin to flash again and you can
make the vertical adjustment so as to place the image at exactly the desired
position. Press the knob to load that value into memory and then rotate the Menu
Select knob to the right until the exit screen is reached:
Adjust Scaler Parameters
Exit
Press the knob to exit the adjustment area and then rotate the knob Counter-
clockwise until you are back at the Banner screen.
These four features represent the areas of highest user interest. An
understanding of these basics is a prerequisite to understanding the C2-
5100/C2-5200 Universal Scaler. You should use this Quick Start tutorial as a get
acquainted exercise because menu navigation (along with the RS-232 interface)
is the basis for unlocking the power of the Scaler. Remember that we haven’t
touched upon many other features. All of that will come later but for now, become
proficient with the four features described above before you move further into the
manual.
8.0
I/O Signal Flow
The Scaler has three RGB inputs (two with HD-15 inputs and one with 5 BNC
inputs), Three Composite Video inputs and Three YC inputs. Provision is made
for RGB outputs (one HD-15 and one set of 5 BNC connectors), a Composite
Summary of Contents for C2-5000 Series
