Triumph Adler P-C3570DN, User Manual

Page: 149 / 255

4-76 Using the Operation Panel
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
1
In the Basic menu, press

or

to select
IPSec
.
2
Press [OK] . The
IPSec
screen appears.
3
Press  or  to select whether IPSec is enabled.
4
Press [OK] . The IPSec setting is set and the Basic menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting
is
Auto
.
1
In the Basic menu, press  or  to select LAN Interface.
2
Press [OK] . The
LAN Interface
screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3
Press

or

to select the desired LAN Interface.
4
Press [OK] . The LAN Interface is set and the Basic menu reappears.
MACAddressFilter (MAC address filtering setting)
This sets whether or not to enable MAC address filtering.
1
In the Basic menu, press

or

to select
MACAddressFilter
.
2
Press [OK] . The
MACAddressFilter
screen appears.
Note
IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
Note
LAN Interface
is only displayed when the optional
network interface kit (IB-50) is installed.
Note
The detailed settings for MAC address filtering are selected
using the optional network interface kit utility software.
IPSec:
a b
1 *Off
2 On
LAN Interface: a b
1
*Auto
2 10BASE-Half
3 10BASE-Full
MACAddressFilter: a b
1 *Off
2
On