Model Two & Model Two Lite - Operation Manual
75
To
a test record from the FILE CONTENT screen:
TIP:
With Fast Setup, you can access the Print Setup menu directly from the FILE
CONTENT screen by pressing
SET
once.
Also, refer to Printer Connection in the next section for instructions on connecting your printer
to the Model Two.
When the Printer has been connected and the proper printer selected in
Printer Setup
, you
can print a selected test record from the FILE CONTENT screen by pressing
F3
(PRINT).
Limit Test
- This data record is printed with Video and Audio levels for each channel along
with a Pass (P) or Fail (F) indication for the channel. This report also shows which Individual
channel test parameters have failed. The listed data is followed by a graphic printout of the
Limit test scan. The total number of channels scanned and the number of channels that have
failed are shown at the bottom of the report.
Tilt Test
- This data record is printed with the Video levels for each Tilt/Favorite channel. The
listed data is followed by a graphic printout of the Tilt levels. The lowest and highest frequency
levels and the Tilt calculation are shown at the bottom of the report.
Spectrum Test
- This data record is printed with the frequency and signal level for each data
point in the Spectrum test. The listed data is followed by a graphic printout of the Spectrum
scan. The minimum and maximum levels in the Spectrum scan are shown at the bottom of the
report.
Scan test
- This data record is printed with Video and Audio levels for each channel. The
listed data is followed by a graphic printout of the Channel scan. The channels with minimum
and maximum Video levels are shown at the bottom of the report.
CAUTION:
Before printing a test record, you must first have the correct
printer selected in the setup menu. (See
Print Setup
on Page 25.)
Note:
The Pass or Fail indication for the Limit Test is based on the Limit
Test parameter setup at the time the Limit Test was performed. A digital
(DIGI) type channel measurement during the Limit Test is shown but is not
used to determine Pass or Fail for any of the tests.
