Software Installation
Installing Windows NT Server 4.0
94
2
Choose "Select from list" from the driver selection menu, and then select "Have
Disk" from its submenu.
3
Insert the Windows NT LAN adapter driver backup floppy disk created above, and
press the
Enter
key.
4
In the next displayed window, select "D-Link DFE-550TX FAST Ethernet 10/100
Adapter" or "Intel PRO @ 100" as applicable to your situation.
Installing the Service Pack
To check whether Windows NT Service Pack 6a or later has been installed:
1
Open the My Computer folder.
2
Select "Version Information" from the Help menu.
The Service Pack version currently installed is displayed under the Windows NT
version information.
❖
If no Service Pack information is displayed or the Service Pack version displayed is 1,
2, 3, 4 or 5, install Service Pack 6a or later and the VIA 4in1 driver.
❖
If Service Pack 6a or later is installed, continue with the following procedure after
installing the VIA 4in1 driver.
Installing the VIA 4in1 driver
Once the installation of Windows NT Server 4.0 is complete, install Service Pack 6a or
later. Install the VIA 4in1 driver before installing the display driver.
1
Insert the
Magnia 510D Software and Documentation
CD-ROM into the CD-ROM
drive, and run the "Setup.exe" which can be located at
<CD-ROM>\Software\MAINBOARD\VIA 4-IN-1
NOTE: After installing the VIA 4in1 driver, check the transfer mode of the IDE
interface by selecting Start, then Programs, and then “VIA DMA TOOL.”
You can set up the Ultra DMA to improve system performance. If IDE hard disk
drives are installed on your server, specify Ultra DMA. To do so, (1) Install the VIA
4in1 driver. (2) Click
Start
, then
Programs
, and select “VIADMATOOL.” (3) Mark
check boxes in the “Current Setting” dialog box. (4) Click
Reboot
to restart the
server.