System Configuration Setup
Setup
74
If a hard disk has not been installed, select
NONE
and press
Enter
.
❖
Drive A type/ Drive B type - Identifies the type of floppy disk drive A or drive B that has
been installed in the server.
❖
Floppy 3 Mode Support - Specifies the storage formats supported by the floppy disk
drive—720 KB, 1.2 MB, and 1.44 MB.
❖
Virus Warning - When set to Enable, the system will halt and display a warning
message if there is any attempt to access the boot sector or partition table of the hard
disk drive. You can run an anti-virus program to locate the problem.
CYLS
Number of cylinders
HEADS
Number of heads
PRECOMP
Write precomp
LANDZONE
Landing zone
SECTORS
Number of sectors
None
No floppy disk drive installed
360K, 5.25-in.
5.25 inch PC-type standard drive; 360 KB
capacity
1.2M 5.25-in.
5.25-inch AT-type high-density drive; 1.2 MB
capacity (3.5-inch when 3 Mode is enabled)
720K 3.5-in.
3.5-inch double-sided drive; 720 KB capacity
1.44M 3.5-in.
(default)
3.5-inch double-sided drive; 1.44 MB capacity
2.88M 3.5-in.
3.5-inch double-sided drive; 2.88 MB capacity
Disable
(default)
Normal floppy disk drive(s).
Drive A
Drive A is 3 mode floppy disk drive
Drive B
Drive B is 3 mode floppy disk drive
Both
Drives A and B are 3 mode floppy disk drives
Enable
Activates automatically when the system
boots up causing a warning message to
appear when anything attempts to access the
boot sector or hard disk partition table
Disable
(default)
No warning message appears when anything
attempts to access the boot sector or hard
disk partition table
