Teledyne ULTRAFLOW 150, Operation Manual, Page: 55 / 162

SECTION 6.0, ENHANCED REMOTE PANEL W/MULTI I/O MODULE
6.4.7.3 Relay Assignments
This screen is password protected . This menu screen sets the condition for
closure for each of the eight output relays on the Multi I/O Board. While
the assignment for a particular relay is highlighted, scroll to the desired
condition using the “Page-Up” and “Page Down” keys. Press
“
↵
” to
select. Move between the relays with the arrow or ENTER keys.
Anytime a selection is changed ENTER must be pressed to confirm the
selection. For a list of the possible selections see Table 6-9, Parameters
for Relay Assignment.
NOTE: On this screen no changes are accepted in the Multi I/O
configuration until the last field, SAVE THIS CONFIG, has been selected
and entered. This field confirms that you want to implement the changes
entered. If one of the fields is not correct, use the
↑
or
↓
key to scroll to it.
Once corrected, move to SAVE THIS CONFIG and press the “
↵
” key.
The ESC key will take you back to the I/O configuration menu .
6.4.8 Display Properties Menu
This screen permits adjustment of the Brightness and Contrast of the
Display. Use the “
↑
” “
↓
” keys to select the parameter you want to adjust.
Then use the “Page-up” and “Page-Down” keys to increase or decrease.
The screen should visually change while pressing these keys. When the
screen looks the way you want it, return to the main screen by pressing
ESC.
An alternate method can be used to adjust the LCD display Contrast and
back-light Brightness:
To increase display Contrast, press “Page-Up” and hold the “
↑
” key.
To decrease display Contrast, press “Page-Up” and hold the “
↓
” key.
To increase display back-light Brightness, press “Page-Down” and hold
the “
↑
” key. To decrease display back-light Brightness, press “Page-
Down” and hold the “
↓
” key.
6.4.9 Software Versions
This screen is not password protected .
6.4.10 System Properties Menu
This menu allows you to choose a group of TIE properties to view or alter.
Monitor calibration is mainly accomplished through use of this group of
screens.
6-19