Teledyne ULTRAFLOW 150, Operation Manual, Page: 53 / 162

SECTION 6.0, ENHANCED REMOTE PANEL W/MULTI I/O MODULE
Figure 6-6
6.4.7.1 Analog Outputs 1,2
This screen is password protected . It configures the Multi I/O Board’s #1
& #2 analog outputs. It chooses:

Parameter to be carried on the output

Whether or not CAL values will be displayed on the output

Numerical value at ZERO scale

Numerical value at FULL scale
As described in previous sections, the physical properties of the outputs
are configured with hardware jumpers on the Multi I/O Board. For a list
of possible output parameters refer to Table 6-10, Parameters for Analog
Output .
When this screen comes up, the parameter for display on output #1 will be
highlighted. Use the “Page Up” and “Page Down” keys to find the
parameter you want. Press “
↵
” to choose and move to the next property.
OUTPUT MODULE CONFIG
Choose
Configuration
Screen
RELAY ASSIGNMENTS
# PRESENT ASSIGNMENT
1 :
xxxx xxxxx xxx
2 : xxxx xxxxx xxx
3 : xxxx xxxxx xxx
4 : xxxx xxxxx xxx
5 : xxxx xxxxx xxx
6 : xxxx xxxxx xxx
7 : xxxx xxxxx xxx
8 : xxxx xxxxx xxx
SAVE THIS CONFIG
ANALOG OUTPUT CONFIG 3 & 4
# Description With Cal.
3 :
xxxx xxxxxx xx xxx
Path : xxxx x xxxx x
Value at 4ma : x.xxE+xx
Value at 20ma : x.xxE+xx
4 : xxxx xxxxxx xx xxx
Path : xxx x xxxx x
Value at 4ma : x.xxE+xx
Value at 20ma : x.xxE+xx
SAVE THIS CONFIG
ANALOG OUTPUT CONFIG 1 & 2
# Description With Cal.
1 :
xxxx xxxxxx xx xxx
Path : xxxx x xxxx x
Value at 4ma : x.xxE+xx
Value at 20ma : x.xxE+xx
2 : xxxx xxxxxx xx xxx
Path : xxx x xxxx x
Value at 4ma : x.xxE+xx
Value at 20ma : x.xxE+xx
SAVE THIS CONFIG
6-17