Teledyne ULTRAFLOW 150, Operation Manual, Page: 147 / 162

ULTRAFLOW 150 GAS FLOW AND TEMPERATURE MONITOR
STATUS HISTORY PRINT OUT
The information contained in the Status History screens can be acquired through serial port using
the following commands:
991?<CR> will print out the Status History for TIE 1
992?<CR> will print out the Status History for TIE 2
There are six possible sets of Status History screens for each TIE. Two sets of Status
History screens are possible for each Path; one for the Primary Status, another for the
Extended Status. There is also a set of history screens for the combined Path A + B/2
configuration. The list is displayed in chronological order with the most recent entry at
the top of the list. The date and time that the status code happened is included on the
same line. A value of zero “0” means that all faults were cleared. If there are no entries
in a specific set of status history screens then nothing will be listed under its heading.
The following is an example what the print out looks like:
991?
TIE1 PATHA PRIMARY STATUS
TIE1 PATHA EXTENDED STATUS
0 1-Mar-2006 8:22:35
10 1-Mar-2006 8:22:01
TIE1 PATHB PRIMARY STATUS
TIE1 PATHB EXTENDED STATUS
0 1-Mar-2006 8:22:35
10 1-Mar-2006 8:22:17
TIE1 PATHAB PRIMARY STATUS
TIE1 PATHAB EXTENDED STATUS
0 1-Mar-2006 8:22:35
10 1-Mar-2006 8:22:17
992?
TIE2 PATHA PRIMARY STATUS
3000 1-Mar-2006 8:28:18
3000 1-Mar-2006 8:26:57
TIE2 PATHA EXTENDED STATUS
TIE2 PATHB PRIMARY STATUS
TIE2 PATHB EXTENDED STATUS
TIE2 PATHAB PRIMARY STATUS
TIE2 PATHAB EXTENDED STATUS
E-2