Teledyne ULTRAFLOW 150, Operation Manual, Page: 49 / 162

SECTION 6.0, ENHANCED REMOTE PANEL W/MULTI I/O MODULE
6.4.5 Status Code Help
This screen is view only. No password is required. The information
displayed is useful in determining the status of the monitor. The screen
contains the five-digit STATUS word and a decoded list of the individual
status conditions. To view this screen select STATUS CODE HELP from
the MAIN MENU by using the arrow keys and press ENTER. Choose the
TIE/Path you want to view with the arrow keys, and press ENTER. This
will bring up the PRIMARY/EXTENDED STATUS selection screen.
Make a selection with the arrow keys and press ENTER. This brings up
the STATUS CODE HELP screen. It has two pages. Switch from page
one to page two with the “Page Up/Page Down” keys. Press the ESC key
to leave the screen. The individual codes are additive. If a SPAN HIGH-
CAL BAD and SPAN LOW-CAL BAD are active at the same time the
STATUS WORD would be “6000”.
Figure 6-4
Note: There are too many potential status codes to combine into one six-digit
octal number. The EXTENDED STATUS is simply a second six-digit
octal number to handle the additional status.
6.4.6 Output Cal Tests
This is a password protected change screen. It allows you to command the
system into different modes of operation. When the screen comes up, the
COMMAND MODE line will be highlighted. Scroll through the modes
PRIMARY STATUS CODES
00001 Purge Failure Dn Stream
00002 Purge Failure Up Stream
00004 Out Of Service
00010 FPGA Config Fault
00020 Temp Out Of Range
00040 Min Signal Energy DnSt
00100 Min Signal Energy UpSt
00200 Span High Offset TD Cal
CURRENT STATUS : XXXXX
PRIMARY STATUS CODES
00400 Span Low Offset TD Cal
01000 Zero Calib Bad
02000 Span High Calib Bad
04000 Span Low Calib Bad
10000 S/N Ratio Warn DnStream
20000 S/N Ratio Warn UpStream
40000 Signal Energy Ratio >3X
100000 Yet To Be Defined
CURRENT STATUS : XXXXX
EXTENDED STATUS CODES
00001 Divide By Zero
00002 FPGA Timeout
00004 3 X FPGA Timeout
00010 Filter Mismatch
00020 BoxCar Overflow
00040 Gain Disabled
00100 Noise Thresh Disabled
00200 Yet To Be Defined
CURRENT STATUS : XXXXX
EXTENDED STATUS CODES
00400 Yet To Be Defined
01000 Yet To Be Defined
02000 Yet To Be Defined
04000 Yet To Be Defined
10000 Yet To Be Defined
20000 Yet To Be Defined
40000 Yet To Be Defined
100000 Yet To Be Defined
CURRENT STATUS : XXXXX
Page #1
Page #2
STATUS CODE HELP
Choose TIE / Path
TIE 1 Path A
TIE 1 Path B
TIE 1 Path AB
TIE 2 Path A
TIE 2 Path B
TIE 2 Path AB
Choose
Primary / Secondary
Status
TIE 1 Path A
Extended
Primar
TIE 2 Path AB
TIE 2 Path A
TIE 1 Path AB
TIE 1 Path B
TIE 2 Path B
Page up / Page Down
6-13