Teledyne T200, Operation Manual, Page: 26 / 425

Getting Started Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual
24
Verify that there is no apparent external shipping damage. If damage has occurred,
please advise the shipper first, then Teledyne API.
Included with your analyzer is a printed record of the final performance characterization
performed on your instrument at the factory. This record, titled Final Test and
Validation Data Sheet (P/N 04490) is an important quality assurance and calibration
record for this instrument. It should be placed in the quality records file for this
instrument.
With no power to the unit, carefully removed the top cover of the analyzer and check for
internal shipping damage by carrying out the following steps:
1. Carefully remove the top cover of the analyzer and check for internal shipping
damage.
a. Remove the setscrew located in the top, center of the Front panel.
b. Slide the cover backwards until it clears the analyzer’s front bezel.
c. Lift the cover straight up.
2. Inspect the interior of the instrument to ensure all circuit boards and other
components are in good shape and properly seated.
3. Check the connectors of the various internal wiring harnesses and pneumatic hoses
to ensure they are firmly and properly seated.
4. Verify that all of the optional hardware ordered with the unit has been installed.
These are listed on the paperwork accompanying the analyzer.
WARNING
– ELECTRICAL SHOCK HAZARD
Never disconnect PCAs, wiring harnesses or electronic subassemblies
while under power.
3.1.1. VENTILATION CLEARANCE
Whether the analyzer is set up on a bench or installed into an instrument rack, be sure to
leave sufficient ventilation clearance.
Table 3-1: Ventilation Clearance
AREA
MINIMUM REQUIRED
CLEARANCE
Back of the instrument
10 cm / 4 in
Sides of the instrument
2.5 cm / 1 in
Above and below the instrument
2.5 cm / 1 in
See Section 1.3 of this manual for various rack mount kit options are available for this
analyzer. Refer to for more information.
06858E DCN7057