Teledyne T200, Operation Manual, Page: 21 / 425

19
2.
SPECIFICATIONS, APPROVALS, & COMPLIANCE
This section presents specifications for the T200, Agency approvals, EPA designation,
and CE mark and safety compliance.
2.1. SPECIFICATIONS
Table 2-1 presents the instrument‟s parameters and the specifications that each meets.
Table 2-1: T200 Basic Unit Specifications
Parameter
Specification
Min/Max Range
(Physical Analog Output)
Min: 0-50 ppb Full Scale
Max: 0-20,000 ppb Full Scale (selectable, independent NO, NO
2
, NO
x
ranges and
auto ranges supported)
Measurement Units ppb, ppm, µg/m
3
, mg/m
3
(selectable)
Zero Noise
1
< 0.2 ppb (RMS)
Span Noise
1
< 0.5% of reading (RMS) above 50 ppb or 0.2 ppb, whichever is greater
Lower Detectable Limit
2
0.4 ppb
Zero Drift < 0.5 ppb (at constant temperature and voltage) /24 hours
Span Drift < 0.5% of Full Scale (at constant temperature and voltage) /24 hours
Lag Time
1
20 seconds
Rise/Fall Time
1
<60 seconds to 95%
Linearity 1% of full scale / 24 hours
Precision 0.5% of reading above 50 ppb
Sample Flow Rate 500 cm
3
/min ± 10%
AC Power Rating
110-120 V~ 60 Hz 3.0 A
220-240 V~ 50/60 Hz 3.0 A
Typical Power Consumption
100 W
110 W
Power, Ext Pump 100 V~, 50/60 Hz 3.25 A
115 V~, 60 Hz 3.0 A
220-240 V~, 50/60 Hz 2.5 A
Analog Output Ranges
10V, 5V, 1V, 0.1V (selectable)
All Ranges with 5% Under/Over Range
Analog Output Resolution 1 part in 4096 of selected full-scale voltage
Recorder Offset
±
10%
06858E DCN7057