Teledyne T200, Operation Manual, Page: 106 / 425

Setup Mode Menus Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual
104
5.9.1. SIGNAL I/O
Use the signal I/O diagnostic mode to review and change the digital and analog
input/output functions of the analyzer. Refer to Appendix A for a list of the parameters
available for review under this menu.
I
MPORTANT
I
MPACT ON
R
EADINGS OR
D
ATA
Any changes of signal I/O settings will remain in effect only until the signal I/O
menu is exited. Exceptions are the Ozone Generator Override and the Flow
Sensor calibration, which remain as entered when exiting.
Access the signal I/O test mode from the DIAG Menu (Figure 5-4), then press:
EXAMPLE
DIAG
SIGNAL I / O
PREV NEXT
JUMP
ENTR
EXIT
DIAG I / O
0) EXT_ZERO_CAL=OFF
PREV NEXT
JUMP
PRNT EXIT
Press JUMP to go
directly to a specific
signal
See Appendix A-4 for
a complete list of
available
SIGNALS
DIAG I / O
JUMP TO: 12
1 2 ENTR
EXIT
EXAMPLE:
Enter 12 to Jump to
12) ST_SYSTEM_OK=ON
DIAG I / O
12) ST_SYSTEM_OK = ON
PREV NEXT JUMP
ON
PRNT
EXIT
Exit to return
to the
DIAG
menu
Press
NEXT
&
PREV
to
move between signal
types.
Pressing the PRNT button will send a formatted
printout to the serial port and can be captured
with a computer or other output device.
Toggle
ON/(OFF)
button to
change status.
06858E DCN7057