Teledyne T200, Operation Manual, Page: 111 / 425

Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual Setup Mode Menus
109
5.9.3.4. AUTOMATIC GROUP CALIBRATION OF THE ANALOG OUTPUTS
I
MPORTANT
I
MPACT ON
R
EADINGS OR
D
ATA
Manual calibration should be used for any analog output set for a 0.1V output
range or in cases where the outputs must be closely matched to the
characteristics of the recording device
.
(See Sections 5.9.3.2, 5.9.3.3, and 5.9.3.6).
I
MPORTANT
I
MPACT ON
R
EADINGS OR
D
ATA
Before performing this procedure, ensure that the AUTO CAL for each analog
output is enabled. (See Section 5.9.3.3).
To calibrate the outputs as a group with the AOUTS CALIBRATION command, select
the ANALOG I/O CONFIGURATION submenu (see Figure 5-5) then press:
From the
AIO CONFIGURATION SUBMENU
Analyzer
automatically
calibrates all
channels for which
AUTO-CAL is turned
ON
If any of the channels have not
been calibrated or if at least one
channel has AUTO-CAL turned
OFF, this message will read NO.
DIAG AIO AUTO CALIBRATING CONC_OUT_1
DIAG AIO NOT AUTO CAL. CONC_OUT_2
This message
appears when
AUTO-CAL is
turned OFF for a
channel
DIAG AIO AOUTS CALIBRATED: NO
SET> CAL EXIT
DIAG AIO AOUTS CALIBRATED: NO
SET> CAL EXIT
DIAG ANALOG I/O CONFIGURATION
PREV NEXT ENTR EXIT
DIAG AIO AUTO CALIBRATING CONC_OUT_3
DIAG AIO AUTO CALIBRATING TEST_OUTPUT
TEST_OUTPUT replaced
by CONC_OUT_4
(O
2
Concentration)
on analyzers with the
optional O
2
sensor
installed.
06858E DCN7057