Suzuki SFV650, Service Manual

Page: 297 / 573

Engine Cooling System: 1F-3
Water Hose Routing Diagram
B944H11602002
2
1
“ e ” “ e ”
“ e ”
“B”
“A”
“ a ”
“B”
“B”
5
“H”
4
“A”
“H”
“B”
“O”
6
“ d ”
“ e ”
“D”
“P”
“C”
“G”
8
7
“ a ”
5
“E”
“J”
“I”
“E”
“A”
“F”
“c”
“ b ”
“ b ”
“M”
“N”
6
“A”
3
“H”
“K”
“A”
“L”
I944H1160055-04
1. Thermostat “H”: Clamp screw head should face left downside.
2. Jiggle valve “I”: Clamp the reservoir tank inlet hose and high-tension cord with the clamp.
3. Radiator outlet hose “J”: Pass the reservoir tank inlet hose forward horn lead wire.
4. Radiator inlet hose “K”: Pass the reservoir tank overflow hose above the high-tension cord and outside
the regulator/rectifier lead wires and below the water hose.
5. Reservoir tank overflow hose “L”: Connect the thinner end of 3-way joint with the reservoir tank overflow hose.
6. Reservoir tank inlet hose “M”: Clamp the oil cooler hoses at the white marking point.
7. Oil cooler outlet hose “N”: Clamp the water pump drain hose and oil pressure switch lead wire.
8. Oil cooler inlet hose “O”: Pass the reservoir tank inlet hose outside of the crankcase breather hose.
“A”: Yellow marking “P”: Clamp the reservoir tank inlet hose at white marking point.
“B”: White marking “a”: 45
°
“C”: Red marking “b”: 0 – 45
°
“D”: Marking “c”: 90
°
“E”: Clamp ends should face downside. “d”: 2 – 8 mm (0.08 – 0.3 in)
“F”: Clamp ends should face upside. “e”: Keep clearance
“G”: Clamp ends should face forward.