Suzuki SFV650, Service Manual

Page: 186 / 573

1C-6 Engine Electrical Devices:
6) Loosen the STP sensor mounting screw (2) adjust
the STP sensor (3) until the output voltage comes
within the specified value and tighten the STP
sensor mounting screw.
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
STP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lbf-ft)
7) Reinstall the removed parts.
STP Sensor Removal and Installation
B944H11306014
Removal
1) Turn the ignition switch OFF.
2) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)”.
3) Disconnect the coupler (1) and remove the STP
sensor (2) with the special tool.
NOTE
Prior to disassembly, mark each sensor’s
original position with a paint or scribe for
accurate reinstallation.
Special tool
: 09930–11950 (Torx wrench)
Installation
1) Disconnect the STVA lead wire coupler (1).
2) Close the secondary throttle valve by finger.
3) With the STV fully closed, install the STP sensor (2)
and tighten the STP sensor mounting screw to the
specified torque.
CAUTION
!
Replace the O-ring (3) with a new one.
NOTE
• Apply a thin coat of engine oil to the O-
ring.
• Align the secondary throttle shaft end “A”
with the groove “B” of STP sensor.
• Apply grease to the secondary throttle
shaft end “A”, if necessary.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
STP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lbf-ft)
3
(a)
2
I944H1130016-01
1
2
I944H1130017-01
1
I944H1130018-01
I718H1130017-01