Suzuki SFV650, Service Manual

Page: 398 / 573

2C-11 Rear Suspension:
Installation
CAUTION
!
The removed bearings must be replaced with
new ones.
1) Press the bearings into the swingarm cushion rod at
0.5 mm (0.02 in) depth “A” from the swingarm
cushion rod surface with the special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09924–84510 (Bearing installer set)
(B): 09941–34513 (Steering race installer)
2) Install the bearing and center spacer.
3) Press the bearings into the swingarm pivot with the
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(B): 09941–34513 (Steering race installer)
4) Apply grease to the bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the swingarm. Refer to “Swingarm Removal
and Installation (Page 2C-8)”.
6) Install the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-11)”.
(B)
(A)
“A”
I944H1230042-01
(B)
I944H1230043-01
I944H1230044-01