Suzuki SFV650, Service Manual

Page: 406 / 573

2D-6 Wheels and Tires:
Front Wheel Related Parts Inspection
B944H12406004
Refer to “Front Wheel Assembly Removal and
Installation (Page 2D-4)”
Tire
Refer to “Tire Inspection in Section 0B (Page 0B-18)”.
Front Brake Disc
Refer to “Front Brake Disc Inspection in Section 4B
(Page 4B-7)”.
Dust Seal
Inspect the dust seal lips (1) for wear or damage. If any
defects are found, replace the dust seal with the new
ones. Refer to “Front Wheel Dust Seal / Bearing
Removal and Installation (Page 2D-7)”.
Wheel Axle
Using a dial gauge, check the wheel axle for runout. If
the runout exceeds the limit, replace the axle shaft.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
Wheel axle runout
Service limit: 0.25 mm (0.010 in)
Wheel
Inspect the wheel in the following procedures:
1) Remove the brake pads. Refer to “Front Brake Pad
Replacement in Section 4B (Page 4B-2)”.
2) Make sure that the wheel rim runout checked as
shown does not exceed the service limit. An
excessive runout is usually due to worn or loosened
wheel bearings and can be reduced by replacing the
bearings. If bearing replacement fails to reduce the
runout, replace the wheel.
3) Install the brake pads. Refer to “Front Brake Pad
Replacement in Section 4B (Page 4B-2)”.
Wheel rim runout
Service limit (Axial and Radial): 2.0 mm (0.08 in)
Wheel Bearing
Inspect the play of the wheel bearings by finger while
they are in the wheel. Rotate the inner race by finger to
inspect for abnormal noise and smooth rotation. Replace
the bearing in the following procedure if there is anything
unusual. Refer to “Front Wheel Dust Seal / Bearing
Removal and Installation (Page 2D-7)”.
1
I944H1240016-02
(A)
(B)
(C)
I649G1240054-02
I649G1240014-02
I649G1240015-02