Suzuki SFV650, Service Manual

Page: 412 / 573

2D-12 Wheels and Tires:
Rear Wheel Related Parts Inspection
B944H12406009
Refer to “Rear Wheel Assembly Removal and
Installation (Page 2D-11)”.
Tire
Refer to “Tire Inspection in Section 0B (Page 0B-18)”.
Rear Brake Disc
Refer to “Rear Brake Disc Inspection in Section 4C
(Page 4C-7)”.
Wheel Damper
Refer to “Drive Chain Related Parts Inspection in
Section 3A (Page 3A-5)”.
Sprocket
Refer to “Drive Chain Related Parts Inspection in
Section 3A (Page 3A-5)”.
Dust Seal
Inspect the dust seal lip (1) for wear or damage. If any
defects is found, replace the dust seal with a new one.
Refer to “Rear Wheel Dust Seal / Bearing Removal and
Installation (Page 2D-13)”.
Wheel Axle
Using a dial gauge, check the wheel axle for runout, If
the runout exceeds the limit, replace the axle shaft.
Wheel axle runout
Service limit: 0.25 mm (0.010 in)
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
Wheel
Inspect the wheel in the following procedures:
1) Remove the brake pads. Refer to “Rear Brake Pad
Replacement in Section 4C (Page 4C-2)”.
2) Make sure that the wheel rim runout checked as
shown does not exceed the service limit. An
excessive runout is usually due to worn or loosened
wheel bearings and can be reduced by replacing the
bearings. If bearing replacement fails to reduce the
runout, replace the wheel.
3) Install the brake pads. Refer to “Rear Brake Pad
Replacement in Section 4C (Page 4C-2)”.
Wheel rim runout
Service limit (Axial and Radial): 2.0 mm (0.08 in)
1
I944H1240031-02
(A)
(B)
(C)
I649G1230034-03
I649G1240014-02