Use of machine
Verti-Mix 951-1651, Verti-Mix 951-L, 1251-L, Verti-Mix 1501 D-3101 D 05.16
107
If the machine is equipped with an on-board hydraulic system
(optional extra), the hydraulic functions of the machine can be
operated only with the propeller shaft powered.
7.1
Fill fodder mixing wagon
WARNING
Risk due to incorrect use of the tractor if this causes failure of components,
insufficient stability and insufficient steerability and braking ability of the
tractor!
Observe the maximum loading capacity of the attached / hitched machine and the
admissible axle and tongue loads of the tractor. Run the machine only with partly-
filled mixing container, if necessary.
WARNING
Risk of crushing, cuts, becoming entangled or being drawn in if people
get into accidental contact with the powered mixing auger due to
improper filling of the mixing container!
●
Only use appropriate equipment to fill the mixing container.
Appropriate equipment may be:
●
Tractor equipped with front loader,
●
telescopic loader,
●
wheeled / yard loader.
●
conveyor system.
●
People are only allowed to fill the mixing container manually if they cannot
accidentally fall into the mixing container.
People are not allowed on a level with or above the feed opening of the
mixing container.
●
As a basic principle, fill pourable fodder additives (e. g. mineral feed) into
the mixing container by means of the loading tool (loading shovel), through
the feed funnel (optional extra) or via a conveyor system.
●
Fill liquid or sticky fodder additives into the mixing container by means of
the loading tool (loading shovel):
●
Fill the loading shovel only partly.
●
Form a hollow in the grass or maize silage.
●
Fill the fodder additives into the hollow.
Or add fodder additives via a conveyor system.
CAUTION
Risk of breakdown of components due to overloading of the machine!
Observe the maximum load of the machine and the filling order of the individual
fodder components.
The fodder components should freely move in the mixing container with the mixing
auger(s) powered. Overload may occur:
●
if fodder components become entangled by the counter-cutters and
blockages pile up.
●
when undoing round bales,
●
due to blunt knives.
Overloading affects the machine’s performance and service life. Damages due to
overloading are excluded from warranty.
