Service and maintenance of machine
Verti-Mix 951-1651, Verti-Mix 951-L, 1251-L, Verti-Mix 1501 D-3101 D 05.16
155
9.17.5
Set hydraulic brake system
Shop work
The brake system must be readjusted if the free travel (X) is greater
than or equal to 40 mm.
WARNING
Risk of injury due to movements of tractor and machine or
machine parts!
Secure tractor and machine against accidental starting and rolling
before carrying out any work on the machine!
Make sure that people leave the hazardous area of the tractor and
the machine or of movable machine parts!
1. Disconnect the hydraulic hose pipe of the
brake system.
2. Manually actuate the brake lever in
pressing direction.
3. Press the circlip at the adjusting screw (1)
down and set the free travel (X) by means
of the adjusting screw:
Free travel (X) = 0.1 x length of brake lever
(Y)
4. Check the brake linings (2).
The brake linings must be replaced in case
of a remaining lining thickness of:
5 mm in case of riveted linings,
2 mm in case of glued linings.
5. Replace the brake linings if necessary.
Fig. 115
9.17.6
Lubrication and maintenance plan
– Chassis
► See also chapter "Lubrication plan", page 127!
Relubricate all lubrication points after cleaning the machine by means
of pressure washers.
