Strautmann Aperion 2101, Translation Of The Original Operating Instructions

Page: 90 / 197

Commissioning
90 Aperion 2101, Aperion 2401, Aperion 3401 04.18
8. Connect the control set.
9.

Connect the lighting system.
10. Lift the supporting leg.
11. Release the parking brake.
5.8.1 Connect hydraulic hose pipes
Check the compatibility of the hydraulic oils before connecting the
machine to the hydraulic system of your tractor.
•
Do not mix mineral oils with bio oils!
•
Observe the maximum admissible pressure of the hydraulic oil
of 200 bar.
•
Only couple clean hydraulic plugs.
•
Insert the hydraulic plug(s) into the hydraulic sleeves until the
hydraulic plug(s) noticeably lock(s).
•
Check the coupling spots of the hydraulic hose pipes for
correct and tight seat.
•
Depressurise hydraulic system.
•
Check the assignment of the hydraulic hose pipes at the
control block of the machine if the coloured markings (dust
caps) are missing:
•
P=Pressure line
•
T (R;S)=Return line
•
Connect the hydraulic system only after it has been
depressurised.
•
Turn the tractor engine off before connecting the hydraulic
system.
•
Always connect the load-sensing control line when connecting
the hydraulic connector "Flow line" to the pressure line leading
to the hydraulic pump of the tractor provided for this purpose.
5.8.1.1 Open hydraulic system
1.

Always swivel the respective operating
element at the control device on the tractor
to floating position.
2.

Turn the tractor engine off.
3.

Unscrew the load-sensing screw (1) at the
electro-hydraulic control block as far as it
will go.
4.

Connect the pressure line (flow line) to a
single-acting or double-acting control
device of the tractor.
5. Connect the tank line (return line) to a
depressurised return line of the tractor.
Fig. 50