Use of machine
Aperion 2101, Aperion 2401, Aperion 3401 04.18
129
7.
Switch the hydraulic drive for the transport floor on.
Switch the tractor's p.t.o. shaft immediately off if the slip clutch responds.
Switch the p.t.o. shaft of the tractor on again.
Let the p.t.o. shaft smoothly start to run.
8.
Start to move and select the travelling speed of the tractor according to the height of the desired
discharged material stack.
For discharge step by step:
Switch the hydraulic drive for the transport floor off.
Switch the tractor's p.t.o. shaft off.
Always adhere to this order when discharging step by step to ensure
that the beaters start to run again without any problems when
switching the p.t.o. shaft on.
9.
Switch the hydraulic drive for the transport floor off.
10.
Switch the tractor's p.t.o. shaft off.
11.
Make sure that people leave the swivelling range of the tailgate.
12.
Close the tailgate.
E-control set
1.
Switch the control set on.
2.
Lock the steering axle before travelling over a clamp silo.
3.
Make sure that people leave the swivelling range of the tailgate.
4.
Open the tailgate completely.
5.
Make sure that people leave the spreading range of the beaters.
6.
Switch the tractor's p.t.o. shaft on.
7.
Let the tractor's p.t.o. shaft smoothly start to run such that the beaters are able to loosen
themselves.
8.
Set the speed for the transport floor feed via the proportional controller.
9.
Switch the hydraulic drive for the transport floor on.
Switch the tractor's p.t.o. shaft immediately off if the slip clutch responds.
Press the key button at the current regulation valve down for a short time if necessary to
reverse the feed direction of the transport floor for a short time. Thus, the pressing power
which the loaded material applies to the beaters, and the starting torque for loosening the
beaters are reduced.
Switch the p.t.o. shaft of the tractor on again.
Let the p.t.o. shaft smoothly start to run.
10.
Start to move and select the travelling speed of the tractor according to the height of the desired
discharged material stack.
For discharge step by step:
Switch the hydraulic drive for the transport floor off.
Switch the tractor's p.t.o. shaft off.
Summary of Contents for Aperion 2101
