Strautmann Aperion 2101, Translation Of The Original Operating Instructions

Page: 151 / 197

Service and maintenance of machine
Aperion 2101, Aperion 2401, Aperion 3401 04.18 151
8.6 Lubrication work
•
Lubricate all bearings according to the lubrication plan.
•
Remove dirt from the lubricating nipples.
•
Use environmentally friendly, biodegradable oils and greases
where lubricants may penetrate the fodder or the ground. For
further information, please contact your specialist for
agricultural machinery.
•
Beware not to exceed a lubricating pressure of 250 bar when
using high-pressure grease guns for lubricating. Damage to
bearings, seals etc. may occur if the grease gun used is not
equipped with a protective device.
8.6.1 Central lubrication
Optional extra
Only use lithium-saponified multi-purpose grease of NLGI class 2.
Only use grease of the same saponifying criteria.
Check the filling level in the grease container before each use. The level must not fall below 1 cm. Top
up the container of the central lubrication early enough.
Only top up the container via the lubricating nipples. Ensure utmost cleanliness.
Keep the cover of the container always closed, thus ensuring that the grease is permanently protected
against the entry of water.
Regularly check the feed lines to the lubrication points for damage or break-off.
8.6.2 Quantities when filled and change intervals
Unit Gearbox
Q
u
ant
it
y
w
h
en
fille
d
[
l]
Lubricant Specification
Int
er
va
l
(h)
Conveyor belt
floor
Feed gearing 3.5
Gear lubricant
oil
EP80W-90 SAE
ISO VG 220
2000
Dosing unit Angular gear 1.2
Gear lubricant
oil
EP80W-90 SAE
ISO VG 320
500