Section 09
BODY/FRAME
Subsection 03
(FRAME)
09-03-2
It is not necessary to center punch the rivet head,
simply center the drill bit on the rivet and drill.
Maintain a slow to medium speed at all times
when drilling. The proper speed is attained when
a constant chip is ejected.
NOTE:
To increase bit life, use Bombardier syn-
thetic chaincase oil (P/N 413 8033 00) as a cutting
oil.
Grinding Procedure
Rear Cap
Grind rivet heads from top of rear cap and under-
neath for side retaining rivets.
1. Rivets heads ground
2. Rivets to be ground from underneath
To remove rivet, strike with a punch from rivet
head side.
Make a chamfer from underneath on all 4 corner
holes.
-
CAUTION
High speed drilling will cause excessive heat
which may destroy the cutting edge of the
bit, therefore avoid using pneumatic drills.
A06H0XA
1
2
Summary of Contents for Formula S 1998
