Section 05
TRANSMISSION
Subsection 04
(DRIVEN PULLEY)
05-04-3
6,9, Sliding Half Bushing and Bushing
To disassemble a worn bushing (small), use a
press and a suitable pusher.
TYPICAL
Remove 3 screws and washers and pry large
bushing out.
INSPECTION
3, Slider Shoe
Check cam slider shoes for wear. Replace when
inside edge of cam slider shoe slope is worn to 1
mm (.039 in) or less.
1. Measure length of slider shoe slope
2. Sliding pulley side
ASSEMBLY
6, Sliding Half Bushing
Clean mounting surfaces with Loctite Safety Sol-
vent. Using a press and a suitable pusher, install
bushing as illustrated.
1. Install bushing from this side of sliding half
2. Bushing
After bushing installation, try fixed half shaft in-
side bushing. If it is too tight, use burnishing bar
(P/N 529 0264 00) then retry. If it is still too tight,
use burnishing bar with oil on it.
8,9, Screw and Bushing
Align notches with screw positions and press
down. Torque screws to 5 N•m (44 lbf•
in
).
3, Slider Shoe
When replacing slider shoes, always install a new
set (3 shoes) to maintain equal pressure on cam.
A25D0KA
A25D0IA
2
1
A25D0LA
2
1
A25D0MA
529 0264 00
Summary of Contents for Formula S 1998
