Ski-Doo Formula S 1998, Shop Manual

Page: 302 / 338

Section 09 BODY/FRAME
Subsection 02 (BODY)
09-02-2
DECAL
To remove a decal; heat old decal with a heat gun
and peel off slowly.
Using isopropyl alcohol, clean the surface and dry
thoroughly.
Apply liquid soap to new decal and carefully posi-
tion the decal. Using a sponge or a squeegee, re-
move the air bubbles and surplus water working
from the center toward the edges. Allow to air
dry.
WINDSHIELD INSTALLATION
When peeling off the protective film some poly-
ethylene particles may remain on the windshield.
A soft clean cloth moistened with naphtha (camp-
ing equipment fuel) will easily remove the remain-
ing particles.
Position the windshield on the hood then push it
down until the tabs are fully inserted into the hood
slots. Lock the windshield tabs in position using
latches as shown.
S-SERIES
1. Latch
2. Temporary remove headlamp molding for windshield installation
BELT GUARD
Disassembly and Assembly
NOTE: For additional information (ex.: exploded
view) refer to the correspondent
Parts Catalog.
Inspection
Check belt guard mounting bosses, clips and re-
tainers for wear.
NOTE: Belt guards are purposely made slightly
oversize to maintain tension on their clips and re-
tainers preventing undue noise and vibration. It is
important that this tension be maintained when
reassembling.
-
CAUTION
Do not apply isopropyl alcohol or solvant di-
rectly on decals.
;
WARNING
Naphtha is flammable and explosive under
certain conditions. Always manipulate in a
well ventilated area. Do not smoke or allow
open flames or sparks in the vicinity.
;
WARNING
Engine should be running only with belt
guard and/or pulley guard well secured in
place.
2
A03H17A
1