Ski-Doo Formula S 1998, Shop Manual

Page: 161 / 338

Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
05-03-12
Assemble fixed and sliding halves. Note that fixed
halves have different cone angle. Match cone an-
gle with crankshaft.
Lift sliding half against spring cover and align
spring cover arrow with sliding half mark.
1. Align
Install and torque screws to 10 N•m (89 lbf• in ).
6,25,29, Sliding Half, Slider Shoe and
Governor Cup
To install governor cup, use following tool:
Insert spring and slider shoes into governor cup
so that groove in each slider shoe is vertical to
properly slide in guides.
Install fork (P/N 529 0055 00) into slider shoe
grooves to maintain them for governor cup instal-
lation. Proceed on 3 set of slider shoes.
Make sure to align governor cup arrow with slid-
ing half and fixed half mark.
NOTE: If fixed half has no mark, align governor
cup mark with segment no. 1 of inner half. Seg-
ments are identified on engine side.
1. Align
Carefully slide governor cup into sliding half. Align
mark of governor cup with mark of fixed half.
Remove forks and push governor cup so that its
splines engage with fixed half shaft splines.
-
CAUTION
Make sure O-rings are installed on slider
shoes and their grooves are positioned ver-
tically.
A16D0DA
1
A16B01A
529 0055 00
-
CAUTION
Make sure splines of both parts are fully en-
gaged.
A16B02A
529 0055 00
A16D0EA
1