Ski-Doo Formula S 1998, Shop Manual

Page: 284 / 338

Section 08 STEERING/FRONT SUSPENSION
Subsection 02 (STEERING SYSTEM)
08-02-3
INSPECTION
Check skis and runner shoes for wear, replace as
necessary. Refer to SUSPENSION AND SKI SYS-
TEM 08-03.
17,36, Steering Arm and Ski Leg
Make sure steering arm and ski leg splines inter-
lock (if applicable).
Check general condition of steering system.
Check general condition of steering system com-
ponents for wear and replace if necessary.
DISASSEMBLY AND ASSEMBLY
8, Grip
Grips can be removed and installed without any
damage by injecting compressed air into the han-
dlebar or by heating them with a heat gun.
1, Steering Column
Remove steering pad then handlebar ass’y.
Detach short tie rod from steering column work-
ing under engine. On S-Series remove air intake
silencer and carburetor(s) to gain access.
17, Steering Arm
To maintain correct steering geometry when reas-
sembling, punch mark the steering arm and ski
leg before removal.
TYPICAL
1. Punch marks
31, Heating Grip Element
On vehicle equipped with heating grips, grips
might be unremovable as explained earlier, in this
case, carefully proceed as follows to prevent
damaging heating elements.
Locate the grip heater wires inside handlebar;
look through end of grip. Start cutting grip exactly
opposite heater wires and immediately peel open
to locate gap in heating element, as shown.
1. Gap in heating element opposite wires
Continue cutting along gap and remove grip. If re-
quired, slowly peel heating element from handle-
bar and remove.
;
WARNING
All parts having worn splines have to be
changed by new ones.
A03G03A
1
A19H04A
1