Section 05
TRANSMISSION
Subsection 06
(BRAKE)
05-06-7
1. Raised edge upward and same side of nuts
INSTALLATION
To install brake, reverse removal procedure paying
attention to the following.
17, Brake Disc
S-Series
The brake disc must be floating on countershaft
for efficient operation of brake.
Apply anti-seize lubricant (P/N 413 7010 00) on
shaft and check that disc slides freely.
The disc hub exceeds the disc more from one
side than from the other. Install disc with the long-
er exceeding portion toward driven pulley.
Push O-rings inside disc hub.
7, Brake Pad
After brake pads installation, brake disc must be
centered in caliper. Apply brake then check for
proper brake disc positioning.
Push on appropriate caliper piston in order to
move pad inward allowing proper brake disc posi-
tioning.
1. Brake disc not centered
2. Brake disc centered
3. Apply brake before checking
Apply brake then recheck.
-
CAUTION
Positioning of rubber slider is important to
avoid the possibility of damage against lock-
ing tab edges.
;
WARNING
Avoid getting oil on brake pads. Do not lubri-
cate or apply antirust or antifreeze solution
in brake cable.
A20D04A
1
A03D13A
1
A03D2KA
2
3
Summary of Contents for Formula S 1998
