Ski-Doo Formula S 1998, Shop Manual

Page: 299 / 338

Section 08 STEERING/FRONT SUSPENSION
Subsection 03 (SUSPENSION AND SKI SYSTEM)
08-03-7
INSPECTION
Check all rubber cushions for crack and wear. Re-
place as required.
Check straightness of splines and proper inter-
locking with steering arm. Replace as required.
Check for straightness of swing arm. Replace as
required.
Check if grease fittings are not clogged.
Check proper action of sliding blocks in swing
arm.
Check skis and runners for wear, replace as nec-
essary.
Check condition of ski stopper. Replace it when
deteriorated.
To check condition of shock on all S-Series mod-
els, refer to Tundra shock inspection.
INSTALLATION
For assembly, reverse the disassembly proce-
dure. However, pay attention to the following.
Apply synthetic grease (P/N 413 7115 00) to ski
leg components.
Tighten nuts and screws to proper torque as men-
tioned in exploded view.
7,8, Upper Half Arm and Tie Rod
Position half arms and tie rods horizontally before
tightening nuts.
9,10,11, Bolt, Nut and Link Plate
Attach link plate to frame with additional nuts and
bolts, if applicable.
TYPICAL — SOME MODELS
1. Nuts and bolts
A06G0CA
1